Mineral Oxychloride vs. Chlorine
Jenfitch mineral oxychloride oxidizes at 2.8–2.9 V versus chlorine's 1.36 V — killing through oxygen radicals rather than chlorination, with no chlorinated by-products and a far lower dose.
Mineral oxychloride oxidizes at 2.8 to 2.9 V against chlorine's 1.36 V, killing through reactive oxygen species rather than chlorination. It forms no chlorinated disinfection by-products, doses at under 1.0 mg/L per mg/L of inorganics versus roughly 6 mg/L for chlorine, and is 12 to 24 times more effective on biofilm, bacteria, viruses, and spores.
Approved, certified & independently validated
EPA FIFRARegistered
USDA OrganicCertified
NSF/ANSIStandard 60
Side by Side
How does mineral oxychloride compare to chlorine?
| Criterion | Mineral oxychloride (JC 9465 / 9450) | Chlorine (Cl2 / NaOCl) |
|---|---|---|
| Oxidation potential (V) | 2.8–2.9 | 1.36 (Cl2); 0.94 (NaOCl) |
| Mechanism | Reactive oxygen species — oxidation by oxygen radicals | Chlorination / oxidative poisoning |
| Relative effectiveness | 12–24× chlorine on biofilm, bacteria, viruses, spores | Baseline |
| Typical dose (inorganics) | <1.0 mg/L per mg/L | ~6 mg/L per mg/L |
| Residual protection | Mildly biocidal mineral-oxide by-products; ORP-verified | Free-chlorine residual (pH-dependent) |
| By-products | No chlorinated DBPs; breaks down existing organics | THMs / HAAs and other chlorinated DBPs |
| Handling / safety | 100% water-soluble ready-to-use liquid; ~6-month shelf life | Corrosive gas or hypochlorite; ~30-day shelf life |
| Capital cost | Minimal — metering pump and ORP controller | Gas rooms / scrubbers or bulk hypochlorite storage |
| Operating cost | Lower dose offsets unit price | Higher dose; DBP management |
| Control method | ORP (mV), tied directly to kill efficacy | Free-chlorine residual / ppm |
Why the Gap
Why does mineral oxychloride kill differently?
Chlorine disinfects by chlorinating and oxidizing cellular structures — effective, but comparatively slow, pH-sensitive, and prone to forming chlorinated disinfection by-products (DBPs) as it reacts with organic matter. Mineral oxychloride works differently: the weakly bound mineral–oxygen complex releases a family of reactive oxygen species (superoxide, hydroxyl radical, singlet oxygen, hydroperoxyl, and peroxide) that attack cell membranes, proteins, and nucleic acids through oxygen radicals rather than chlorine poisoning.
That mechanism is why the numbers diverge. Against a Salmonella enterica challenge (30 minutes, 2.0×107 CFU/mL starting load), JC 9465 delivered a 6.60 log reduction at just 2 ppm, while sodium hypochlorite needed 100 ppm to reach a comparable 6.49 log — and managed only 2.02 log at 10 ppm. Overall, the chemistry is 12–24× more effective than chlorine at controlling biofilms, bacteria, viruses, and spores, and it works in places where chlorine struggles, such as inside established biofilm.
Lower dose, no chlorinated by-products
Because each molecule generates multiple oxidizing species and the reaction is effectively catalytic, the dose is low: below 1.0 mg/L per mg/L of inorganics, compared with roughly 6 mg/L for chlorine. And because the active species are oxygen radicals rather than chlorine, treatment does not add chlorinated DBPs — in fact the oxidation breaks down organics that would otherwise form them. The mineral-oxide by-products that remain are mildly biocidal, resist recontamination, and fall below FDA limits.
Handling and control
Mineral oxychloride ships as a 100% water-soluble, ready-to-use liquid with roughly a six-month shelf life — about six times that of sodium hypochlorite — and is dosed to a target ORP rather than by ppm alone. Holding roughly +600 mV creates a disinfection barrier; +700 mV delivers a 6-log kill in under 10 seconds. JC 9465 is EPA FIFRA registered and USDA NOP Organic certified; JC 9450 is NSF/ANSI Standard 60 certified.
The Benchmark
Oxidation potential of common oxidants.
| Oxidant | Oxidation potential (V) |
|---|---|
| Fluorine | 3.06 |
| Mineral oxychloride (JC 9465 / JC 9450) | 2.8–2.9 |
| Hydroxyl radical (•OH) | 2.80 |
| Ozone (O3) | 2.07 |
| Chlorine dioxide (ClO2) | 1.57 |
| Hypochlorous acid (HOCl) | 1.49 |
| Chlorine (Cl2) | 1.36 |
| Sodium hypochlorite (NaOCl) | 0.94 |
| Superoxide (O2−) | −2.40 |
The takeaway
Where you need stronger, faster oxidation without chlorinated by-products — especially on biofilm, in food and produce, or where chlorine underperforms — mineral oxychloride delivers higher potential (2.8–2.9 V), a lower dose, and ORP-verified control. Chlorine remains a sound, inexpensive residual disinfectant for many distribution systems.
Frequently Asked Questions
Mineral oxychloride and chlorine.
Is mineral oxychloride stronger than chlorine?
Yes. Its effective oxidation potential of 2.8–2.9 V is well above chlorine's 1.36 V (and sodium hypochlorite's 0.94 V), and it is 12 to 24 times more effective than chlorine against biofilm, bacteria, viruses, and spores. The difference is mechanistic: mineral oxychloride kills through reactive oxygen species, oxidizing by oxygen radicals, while chlorine works by chlorination and oxidative poisoning. That higher potential is also why the required dose is far lower.
Does it form the same by-products as chlorine?
No. It kills through oxygen radicals rather than chlorination, so it does not add chlorinated disinfection by-products such as THMs and HAAs, and it breaks down existing organics that would otherwise form them. Chlorine gas and sodium hypochlorite, by contrast, disinfect by chlorination and generate chlorinated DBPs. The by-products left by mineral oxychloride are mildly biocidal mineral oxides, and dosing is verified by measuring oxidation-reduction potential rather than a free-chlorine residual.
How much less product do I need?
For inorganics, dosing is below 1.0 mg/L per mg/L of inorganics, compared with roughly 6 mg/L for chlorine. The lower dose helps offset the higher unit price. Because the chemistry oxidizes at 2.8–2.9 V rather than chlorine's 1.36 V, less product is needed to reach the same oxidative work, and capital cost stays minimal because feeding it requires only a metering pump.
Can it replace chlorine everywhere?
Not always. Chlorine remains an economical, well-understood residual disinfectant for distribution systems, where its pH-dependent free-chlorine residual is familiar to operators. Mineral oxychloride is the stronger choice where chlorine underperforms, including biofilm, food and produce, and cooling systems, and it can be run alongside existing chlorinated protocols rather than displacing them. Its own residual protection comes from mildly biocidal mineral-oxide by-products and is verified by ORP.
How is it dosed and verified?
As a 100% water-soluble, ready-to-use liquid dosed to a target oxidation-reduction potential (ORP) in millivolts, fed by a metering pump under ORP control. Roughly +600 mV establishes a disinfection barrier and +700 mV delivers a 6-log kill in under 10 seconds. Because ORP ties directly to kill efficacy, the meter reading is the verification. The product has about a six-month shelf life. See the ORP chart.